PSP VR1-120-4XM 120VAC 1-Phase Voltage Regulator with 4-Mode Protection

PSP VR1-120-4XM 120VAC 1-Phase Voltage Regulator with 4-Mode Protection

$169.95
Skip to product information
PSP VR1-120-4XM 120VAC 1-Phase Voltage Regulator with 4-Mode Protection

PSP VR1-120-4XM 120VAC 1-Phase Voltage Regulator with 4-Mode Protection

$169.95

Call 800-634-3874 for Trade Discounts and Quantity Pricing

Service Entrance Panel and Equipment Surge Protector Type- 120/240v Rated at 120Ka per phase

The PSP VR1-120-4XM is a 120VAC single-phase voltage regulator engineered to deliver clean, stable power to sensitive equipment. With 4-mode protection, this unit guards against surges, spikes, sags, and noise — ensuring your connected devices receive consistent, regulated voltage regardless of utility fluctuations.

Why Choose the VR1-120-4XM?

  •  Imax: 120kA per phase
    • In: 20kA
    • Thermally protected MOV suppression, capacitive 
    filtering and gas discharge tube 
    • LED indicator and audible alarm
    • EMI/RFI noise filtration (-40db)
    • Repositionable face cover allows for label orientation
    • Meets UL 96A lightning protection master label
    • NEMA 4X (IP65/IP66) indoor/outdoor rated enclosure
    • Available with Series R or Generator label

Ideal For:

  • Whole house protection at the service entrance for 100-200- Amp boxes. 
  •  Ideal for individual poultry house and hog house protection

Installation

1.Confirm VR device is rated for your system by 
comparing voltage measurements to the line 
voltage on the product label.
2.Turn off all power supplying this equipment  
before working on or inside the equipment.
3.See installation diagrams below and match to your 
specific installation type.
4.If installing on a breaker, use a 20A-60A breaker and 
verify lug on breaker provides solid connection to SPD 
wiring.
5.In some jurisdictions, provided flat tabs can be used in 
the bottom of the lug.
6.As a Type 1, no breaker is required.
7.Install in accordance with all pertinent articles of the 
National Electric Code. 
8.Confirm that the electrical terminals used to attach 
this device are identified for these conductors.
9.Keep conductor length as short as possible with no 
sharp bends.
10. Do not loop or coil wires. 
11. Ensure a high-quality ground is in place.
12. Turn on all power supplying this equipment.
13. Verify diagnostic indicator is illuminated and no 
audible alarm is present.
14. Install cover and/or close door on equipment fixture.

Protection You Can Count On: PSP Products is a trusted manufacturer of power protection devices built to rigorous safety standards, delivering reliable voltage regulation and surge suppression for facilities where equipment downtime and damage are not an option.

You may also like